I sprayed a clear coat via air compressor setup and have a problem.?

-It looks like water was spitting out of the line as well as the urethane clear coat and you can see water bumps on the bumper. Will this evaporate as the urethane dries or do I need to sand it down and use a better compressor setup?The water will evaporate but the damage is already done.



I would suggest that you go get a moisture separator for your compressor.



This will eliminate the water that is fouling up your paint job.



Let it dry, wet sand it smooth and reshoot. It will be worth it.
Best to let it dry and see how bad, you may be able to buff it out. Probably not though, so you might need to start again. What thinning ratio are you using, and what did you last clean the equipment with ?>